HY-LUX GRAY WATERBORNE INDUSTRIAL PRIMER

Starting at: $46.14

  • Model: ELL.1263
  • 100 Units in Stock
  • Manufactured by: Ellis Paint

HY-LUX  WATERBORNE INDUSTRIAL PRIMER is a low V.O.C., quick-dry, rust inhibiting,acrylic based primer with excellent adhesion properties to a wide variety of substrates, including steel, plastic, wood and plaster-drywall. This primer is an excellent choice for areas that require a tough and durable primer. 1262 White Primer has been USDA approved as a primer in areas subjected to incidental food contact.

Partial List of Uses:  
  • Hospitals, schools 
  • Aircraft support equipment
  • Food processing plants
  • Hotels, motels
  • Equipment maintenance
  • Doors - metal and wood
  • Wineries
  • Machinery
  • Metal buildings - interior

Benefits:
  • Fast drying
  • Water reducibl
  • Non-flammable
  • Corrosion resistant
  • Good flexibility
  • Easyapplication
  • Meets clean air standards
  • Outstanding adhesion


Product Number: 1262 (white), 1263(gray), 1272(red oxide)
Colors: White, Gray, Red Oxide


SURFACE PREPARATION:
GENERAL:
All surfaces to be painted must be clean, dry and in fit condition to be painted. Be sure to remove all wax, silicone, oil, powdery or scaling rust, loose or peeling paint and all other foreign matter. Smooth, slick surfaces should be sanded to promote adhesion. Prime bare and uncoated surfaces with Hy-Lux Primer BARE FERROUS METALS: Clean off all dirt, grease, oil, wax or other foreign matter. All loose, powdery or scaling rust must also be removed. A completely de-rusted surface is recommended. Prime bare and uncoated surfaces with Hy-Lux Primer.

NON-FERROUS METALS:
Clean the surface thoroughly. Apply a prep coat of Hylux 690 Low VOC Etching Filler as a first coat over the non-ferrous metal to etch the surface and promote adhesion. Allow 30 minutes to dry and follow with an appropriate Ellis Primer within 8 hours. After 8 hours, the Hylux 690 Low VOC Etching Filler should be lightly sanded before applying the first coat of Ellis Primer.

BARE WOOD: Clean wood thoroughly. Prime and seal with one coat of Hy-Lux Primer or HY-LUX

WATERBORNE INDUSTRIAL ENAMEL (tinted close to finish color, if desired).

PAINTED SURFACES: Be sure all loose and peeling paint is completely removed, and the surface is clean. Remove excess chalkiness with a wire brush or by sanding. Feather edge and spot prime with Hy-Lux Primer.

For a complete product data sheet and MSDSs please contact us.

For Product delivery greater than 60 miles from the San Fernando Valley California please contact us for shipping information


Add to Cart:

Please Choose:




Online Payments
Copyright © 2014 Annex Paint and Lacquer
Design by: IDEAS | Powered by Zen Cart